ACTH 片段 comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-02-17. Where a claim depends on a specific study, the study is described rather than over-claimed.
Scientific literature on semax is unevenly distributed. A substantial share of published work originates from a small number of laboratories in Russia, while independent replication elsewhere is limited. Human data consist mostly of small trials with short follow-up, and several reported outcomes rely on subjective rating scales. Questions about how much intact peptide reaches the central nervous system after nasal administration, and how long it persists there, are still unresolved. The compound is best described as an active research subject rather than a settled pharmacological agent.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It was derived from the ACTH(4-10) fragment, a short segment of adrenocorticotropic hormone that lacks the hormonal activity associated with the full-length peptide. Researchers at the Institute of Molecular Genetics in Moscow developed the compound during the 1980s. It has been registered as a pharmaceutical product in Russia and several neighbouring countries, where it is supplied as a nasal solution, and it is also sold internationally as a research chemical.
Practical handling follows from those properties. Bulk material is best divided into single-use portions soon after receipt, because each thaw exposes the whole container to moisture and temperature cycling. Vials should be allowed to reach room temperature before opening to prevent condensation on the powder. Low-binding plasticware reduces loss of dilute solutions, and sterile filtration is used when a preparation must remain free of microbial growth. Records of batch number, reconstitution date and storage history are what allow a later analytical result to be interpreted meaningfully.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C37H51N9O10S | Calculated for the free peptide |
| Molar mass | 813.9 g/mol | Anhydrous free base |
| Peptide class | Synthetic heptapeptide | ACTH(4-10) analogue |
| Parent fragment | ACTH(4-10) | Adrenocorticotropic hormone segment |
| Developmental origin | Institute of Molecular Genetics, Moscow | Work began in the 1980s |
The compound was developed during the 1980s at the Institute of Molecular Genetics in Moscow as part of research on fragments of adrenocorticotropic hormone. Early work examined short ACTH-derived sequences that retained neurotrophic effects while lacking the endocrine activity of the full hormone. Semax entered clinical use in Russia during the 1990s, where it received registration for several neurological indications. Outside that region it remained primarily a laboratory research material rather than an approved therapeutic. English-language literature on it grew more slowly and frequently cited the original Russian studies.
Terminology around the compound varies by source. It appears in catalogues and papers as Semax, as the heptapeptide ACTH(4-7)-Pro-Gly-Pro, and under various alphanumeric laboratory codes used by individual suppliers. These names refer to the same sequence but may imply different salt forms, purity grades, or counter-ions. Peptide databases usually list the free base mass, while product descriptions sometimes report acetate or trifluoroacetate salts with a different formula weight. Because naming conventions for research peptides are not standardised across vendors, checking the declared sequence and measured mass is more reliable than relying on a trade name alone.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. Its design combines the ACTH(4-7) core fragment with a C-terminal Pro-Gly-Pro extension, a modification intended to improve stability and prolong activity. The molecule is hydrophilic, carries no lipid chains or glycosylation, and has a theoretical mass just over 810 daltons in its free form. All seven residues are proteinogenic amino acids, so no non-natural building blocks appear in the backbone. A free N-terminal methionine and C-terminal proline define the unmodified parent peptide.
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Identity and purity are commonly assessed by reversed-phase high-performance liquid chromatography, with ultraviolet detection near 214 nanometers for the peptide backbone. Mass spectrometry, either electrospray or matrix-assisted laser desorption, confirms molecular mass and detects truncation or modification products. Amino acid analysis can verify composition. Because the sequence contains no strongly absorbing aromatic residue apart from phenylalanine, detection wavelengths are chosen carefully. Purity values above 95 percent are typical for research-grade material.
各国监管态度分化明显。俄罗斯按处方药管理，部分东欧国家留有使用记录；欧盟与美国未批准其作为药物上市，市面流通品通常标注为研究用化学品。身份差异意味着标示含量、纯度与无菌性缺少统一核查。体育领域还牵涉反兴奋剂名录，跨境携带则受目的地药品法规约束。
Semax 是人工设计的七肽，序列为 Met-Glu-His-Phe-Pro-Gly-Pro，骨架取自促肾上腺皮质激素片段 ACTH(4-10)。它于二十世纪八十年代在苏联的分子遗传学研究机构内合成。设计目标是保留该片段与注意力和记忆相关的活性，同时剔除促皮质激素释放等内分泌作用。此后俄罗斯将其登记为药品并进入临床使用。
Formaldehyde levels in building environments are affected by a number of factors. These include the potency of formaldehyde-emitting products present, the ratio of the surface area of emitting materials to volume of space, environmental factors, product age, interactions with other materials, and ventilation conditions. Formaldehyde emits from a variety of construction materials, furnishings, and consumer products. The three products that emit the highest concentrations are medium-density fiberboard, hardwood plywood, and particle board. Environmental factors such as temperature and relative humidity can elevate levels because formaldehyde has a high vapor pressure. Formaldehyde levels from building materials are the highest when a building first opens because materials would have less time to off-gas. Formaldehyde levels decrease over time as the sources suppress. In operating rooms, formaldehyde is produced as a byproduct of a process known as electrosurgery and is present in surgical smoke, exposing surgeons and healthcare workers to potentially unsafe concentrations. Formaldehyde levels in air can be sampled and tested in several ways, including impinger, treated sorbent, and passive monitors. The National Institute for Occupational Safety and Health (NIOSH) has measurement methods numbered 2016, 2541, 3500, and 3800.
Defatted soy flour is obtained from solvent extracted flakes and contains less than 1% oil. "Natural or full-fat soy flour is made from unextracted, dehulled beans and contains about 18% to 20% oil." Its high oil content requires the use of a specialized Alpine Fine Impact Mill to grind rather than the usual hammer mill. Full-fat soy flour has a lower protein concentration than defatted flour. Extruded full-fat soy flour, ground in an Alpine mill, can replace/extend eggs in baking and cooking. Full-fat soy flour is a component of Cornell bread. Low-fat soy flour is made by adding some oil back into defatted soy flour. Fat levels range from 4.5% to 9%. High-fat soy flour can also be produced by adding back soybean oil to defatted flour, usually at 15%. Soy lecithin can be added (up to 15%) to soy flour to make lecithinated soy flour. It increases dispersibility and gives it emulsifying properties. Soy flour has 50% protein and 5% fiber. It has higher levels of protein, thiamine, riboflavin, phosphorus, calcium, and iron than wheat flour. It does not contain gluten. As a result, yeast-raised breads made with soy flour are dense in texture. Among many uses, soy flour thickens sauces, prevents staling in baked food, and reduces oil absorption during frying. Baking food with soy flour gives it tenderness, moistness, a rich color, and a fine texture. Soy grits are similar to soy flour, except the soybeans have been toasted and cracked into coarse pieces. Kinako is a soy flour used in Japanese cuisine. Section reference: Circle & Smith (1972, p. 442)
beaker A cylindrical vessel or container with a flat bottom, most commonly a type of glassware, widely used in laboratories for a variety of purposes, such as preparing, holding, containing, collecting, or volumetrically measuring chemicals, samples, or solutions, or as a chamber in which a chemical reaction occurs. Beakers are distinguished from flasks by having straight rather than sloping sides; most beakers also have a small spout in the rim to aid pouring.
For services to Child Road Safety. Kenneth Fitzpatrick. Lifeboat Operations Manager, Porthdinllaen Lifeboat Station, Royal National Lifeboat Institution. For services to Maritime Safety. Barry Flack. For services to the Jewish Community in the London Borough of Barnet. Margaret Elizabeth Flanagan. Member, Inner Wheel Club of Ballymena. For voluntary services to the community in Ballymena, County Antrim. John Campbell Forrester. President and Poppy Appeal Organiser, Driffield Branch, Royal British Legion. For voluntary service to Veterans in East Yorkshire. Claire Forsythe. Duke of Edinburgh's Award Officer, Probation Board for Northern Ireland. For services to the Rehabilitation of Offenders. Susan Joan Foster. For voluntary service in Hampshire. Richard Charles Fowler. Library Lead, Harbury Community Library, Warwickshire. For services to Libraries. Dr Jennifer Ann Frow. Volunteer, Bewdley Tennis Club. For services to Lawn Tennis in Worcestershire. Robert Francis Fyfe. Chair and Director, Runway Theatre Company. For services to the Arts and to the community in Glasgow. Melanie Jane Gardner. Fine and Decorative Arts Curator, Tullie House Museum, Carlisle. For services to Arts and Culture in Cumbria. Joseph William Garvey. For services to the community in County Armagh. Peter William Garwood. For services to the community in Barrow-in-Furness, Cumbria. Christine Frances Gatfield. Founder, Dove Cottage Day Hospice. For services to the Terminally Ill. Patricia Mary Gaywood. Membership Secretary, The Forty Club. For voluntary service to Cricket. Andrew Gell.
== COVID-19 pandemic == ADLM members who are frontline laboratory specialists also encounter significant challenges in carrying out such studies. Lack of product selection and research materials as well as personal protective equipment, known as PPE, are the most important of these barriers. In recognition of these obstacles to optimizing research ability, ADLM sent a letter to the Coronavirus Task Force advising the Task Force and White House to minimize supply chain issues, and to identify and organize tools such that doctors, nurses, laboratory personnel and other healthcare staff may do their jobs. ADLM has produced instructional videos demonstrating serology, treatment of polymerase chain reaction (PCR), and more through research in the spotlight during the COVID-19 pandemic.
Sources: en.wikipedia.org
Importantly, the NPYS group can replace the Acm PG to yield an activated thiol. Using this method, Kiso and coworkers reported the first total synthesis of insulin in 1993. In this work, the A-chain of insulin was prepared with following protecting groups in place on its cysteines: CysA6(But), CysA7(Acm), and CysA11(But), leaving CysA20 unprotected.
=== Social anxiety disorder === SSRIs show some evidence of effectiveness for social anxiety disorder, including reducing relapse and disability, but the overall quality of evidence is low to moderate and tolerability is slightly lower than placebo.
=== Mumps === Mumps is another viral disease that was once very common, especially during childhood. If mumps is acquired by a male who is past puberty, a possible complication is bilateral orchitis, which can in some cases lead to sterility.
Sucre wanted to delay any union of Bolivia with Peru as long as possible (knowing that it would fall under the latter's hegemony when it passed, weakening his government), annex all the territories offered by Ortiz, confront Colombia with Peru, secure his back by agreeing with Chile and Buenos Aires, and separate Arequipa, Cuzco and Puno from Peru. All this is demonstrated when Sucre indicated to Ortiz de Zevallos that: "only under that plan could Bolivia not fear that Peru would absorb it, as happens when a small State links up with a larger and stronger one". As well as when in 1827, Sucre appointed dean Gregorio Funes, a Bolivarian Argentine, who was carrying out the functions of Colombian minister in Buenos Aires, to receive the post of Bolivian minister in the same Argentine capital. Through Funes, Sucre addressed the issue of an alliance between Bolivia, Argentina and Chile, which was supposedly to stop Brazilian expansionism, but in practice he was looking for support against Peru because he knew its weakness against it, and suggested that the participation of Gran Colombia in the war against Brazil could occur through a treaty. From Santiago de Chile, Andrés Santa Cruz interpreted Sucre's opening to Buenos Aires as an attempt to form "an anti-popular and very particularly anti-Peruvian pact." The negotiations did not prosper because the Peruvians also sent agents who assured that Bolívar intended to divide the continent between two great empires: one Colombian and the other Brazilian.
Sources: en.wikipedia.org
Semax is based on the ACTH(4-10) fragment, a seven-amino-acid segment of adrenocorticotropic hormone. The synthetic peptide retains the core sequence while removing regions associated with endocrine activity. This modification is intended to isolate effects on the nervous system.
It is registered for clinical use in Russia and a few other countries, typically as a nasal drop formulation. It does not hold approval from the United States Food and Drug Administration or the European Medicines Agency. Outside those markets it is generally handled as a research chemical.
The compound was developed in Moscow and the earliest studies were conducted there, so the primary literature is largely in Russian-language journals. Translation and indexing have been incomplete, which limits access for outside researchers. Independent groups have since published some work, but the total volume remains modest.
Suppliers normally quote a percentage of total chromatographic peak area, most often from reversed-phase HPLC. That figure says nothing about what the remaining percentage contains, and it depends on the detection wavelength used. A mass spectrometry result is a separate and stronger check on identity.